Back to Contents Page
Setting Up the Monitor
Dell™ IN2010N Flat Panel Monitor User's Guide
Attaching the Base
Connecting the Monitor
Attaching the Soundbar (Optional)
Removing the Base
Attaching the Base
NOTE: The base is detached when the monitor is shipped from the factory.
After placing the monitor panel on a soft cloth or cushion, complete the following steps to attach the base.
1.Place the monitor on a flat surface.
2.Attach the base to the monitor.
Connecting Your Monitor
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions.
To connect your monitor to the computer perform the following steps/instructions:
1.Turn off your computer and disconnect the power cable.
2.Connect the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer.
Connecting the blue VGA cable
NOTE: The Graphics are used for the purpose of illustration only. Appearance of the the computer may vary.
After you have completed connecting the VGA cable, follow the procedure below to complete your monitor setup:
1.Plug the power cables for your computer and monitor into a nearby outlet.
