Dell M8428-k Hardware Reference Manual 17
53-1001980-01
Changing from NPIV aggregator mode to full fabric mode 2
These commands upload the converged network switch configuration to the server, making it
available for downloading to a replacement converged network switch if necessary. Dell
recommends backing up the configuration on a regular basis to ensure that a complete
configuration is available for downloading to a replacement switch module.
Changing from NPIV aggregator mode to full fabric mode
If your converged network switch is currently configured in NPIV mode, you can enable the module
for full fabric mode by disabling NPIV mode. When you do this, the module automatically reboots in
full fabric mode.
Determine if the switch module is running in NPIV mode by entering the switchShow CLI command
to display the current switch configuration. If running in NPIV aggregator mode, the switchMode
parameter will display Access Gateway.
NOTE
Disabling NPIV mode is disruptive because the switch is disabled and rebooted. Always back up the
current configuration before enabling or disabling NPIV mode. Enabling NPIV mode clears the
security and zone databases. Disabling NPIV mode clears the F_Port to N_Port mapping.

Changing to full fabric mode using the browser-based GUI

Complete the following steps to enable full fabric mode using the browser-based GUI.
1. From the management console, open a Web browser.
2. Enter the IP address of the converged network switch into the Address field of the Web
browser.
3. Log into the browser-based GUI using the default administrative account.
Login: admin
Password: password
4. From the Fabric Tree, select the converged network switch.
The selected switch module appears in the Switch View.
5. Click the Switch Admin button in the browser-based GUI Manage task box.
The Switch Administration window opens.
NOTE
You should save the configuration file if you are converting an converged network switch to NPIV
mode. To save your current configuration, click the Show Advanced Mode button in the top
right-hand corner of the Switch Administration window. Select the Configure tab, then select the
Upload/Download tab. Enter the relevant information to upload the configuration file.
6. From the Switch Status section, click Disable.
7. From the NPIV Mode section, click Disable.
8. Click Apply.
9. When prompted, click Yes to restart the switch module in full fabric mode.