Back to Contents Page
Palm Rest
Dell™Inspiron™N5020/M5030/N5030ServiceManual
Removing the Palm Rest
Replacing the Palm Rest

Removing the Palm Rest

1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the ten screws that secure the palm rest to the computer base.
4. Remove the keyboard (see Removing the Keyboard).
5. Disconnect the speaker cable from the connector on the system board.
6. Lift the connector latches and pull the pull-tabs to disconnect the touch pad cable and power button cable from their connectors on the system board.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
CAUTION: To avoid damage to the connectors, lift the connector latch and then remove the cables.
CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking
tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.