Dell P170s, P190S appendix Setting Up the Monitor, Attaching the Stand, Connecting the Monitor

Models: P190S P170s

1 37
Download 37 pages 8.73 Kb
Page 19
Image 19
Back to Contents Page

Dell P170S/P190S Flat Panel Monitor User's Guide

Back to Contents Page

Setting Up the Monitor

Dell™ P170S/P190S Flat Panel Monitor User's Guide

Setting Up the Monitor Attaching the Stand

Dell™ P170S/P190S Flat Panel Monitor User's Guide Connecting the Monitor

 Attaching the Stand Organizing Your Cables

 Attaching the Soundbar (Optional) Attaching the Soundbar (Optional)

Attaching the Stand Removing the Stand

Attaching the Stand

Connecting the Monitor NOTE: Stand is detached when the monitor is shipped from the factory.

NOTE: This is applicable for a monitor with a stand. When the OptiPlex™ USFF 780/OptiPlex™ SFF 980 AIO Stand is bought, please refer to the respective AIO stand setup guide for set up instructions.

Remove the monitor cover and place the monitor on it.

1.Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.

2.Lower the stand so that the monitor mounting area snaps onto the stand.

Connecting the Monitor

Manual background WARNING: Before you begin any of the procedures in this section, follow the safety instructions.

To connect your monitor to the computer perform the following steps/instructions:

1.Turn off your computer and disconnect the power cable.

2.Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not connect both

file:///S/SSA_Proposal/P170S_P190S/UG/setup.htm[7/8/2011 4:49:17 PM]

Page 19
Image 19
Dell P170s, P190S appendix Setting Up the Monitor, Attaching the Stand, Connecting the Monitor, Back to Contents Page