170 Adding and Replacing Parts

Replacing the Optical Drive

1
Slide the optical drive into the bay.
2
Replace and tighten the locking screw.
Central Control Cover
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.
1 optical drive 2 locking screw 3 notch
1
2
3
book.book Page 170 Wednesday, September 16, 2009 11:12 AM