Dell S520 manual Installation

Installation (continued)

NOTE: The (3) 1/4” x 1-1/2” bolts and (3) washers required in Steps 6-8 are NOT INCLUDED with the screen/whiteboard packaging.

6.Install (1) 1/4” x 1-1/2” bolt and (1) washer through middle of bracket into previously drilled hole, leaving 1/2” of the bolt extending from wall. Use carpenter’s level to make sure bracket is properly level (Figure 2).

7.Position level on top of wall bracket. Move bracket until level. Drill (2) holes for the other bolts in wall studs.

8.Install the other (2) 1/4” x 1-1/2” bolts and (2) 1/4” washers in the previously drilled holes. Tighten all bolts against wall bracket.

9.Measure down 52-1/4” on center and mark spot. Move right and left of screen until wall studs are found and mark (Figure 3).

Center of

Screen

Previously

Drilled Hole

Middle Fastener

Figure 2

Center of Screen

52-1/4 in.

Figure 3

6