FASTENING THE COOKTOP
Each cooktop is supplied with a set of tabs and screws to fasten it on units with a work- ing surface from 3 to 4 cm deep.
The kit includes 4 tabs A and 4
•Cut the unit.
•Turn the hob upside down and rest the glass side on a cloth.
•Spread the seal C around the edge of the hob (fig. 4.5).
•Put tabs A into the mountings; only tighten screws B a few turns.
Make sure that the tabs are mounted correctly as shown in the figure 4.4.
•Put the cooktop into the hole cut into the unit and position it correctly.
•Put tabs A into place, tooth D of the tabs should go into the hole.
•Tighten screws B until the cooktop is completely secured.
•Using a sharp tool cut off the part of gasket C which protrudes from the cooktop. Take care not to damage the workbench.
20
|
| C |
|
D |
|
|
|
B | A | mm min. | mm max. |
Fig. 4.4 |
| 30 | 40 |
A
C
C | A |
Adhesive side | Fig. 4.5 |
