DeLonghi DEFSGG 24 SS Levelling the Range, ANTI-TIP Stability Device Installation Instructions

LEVELLING THE RANGE

The range is equipped with 4 LEVELLING FEET and may be levelled by screwing or unscrewing the feet with a spanner (fig. 1.8).

It is important to observe the directions of figures 1.6, 1.7a, 1.7b.

Fig. 1.6

Supplied with the range in a separate kit

0 mm 0"

+8 mm

+5/16"

+ 8 mm + 5/16"

Fig. 1.7a	+ 20 mm	Fig. 1.7b
	+ 25/32"

Fig. 1.8

YOU MUST USE STABILITY ANTI TIP BRACKET TO PREVENT UNIT FROM TIPPING.

ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS

1.The anti-tip bracket has to be attached as shown on figure below (only rear right side), it has to be fixed on the floor and on the rear wall by no. 4 (four) suitable screws (not supplied).

2.After fixing the anti-tip bracket, slide range into place. Be sure the rear right foot slides under the anti-tip bracket attached.

Dotted line showing the position of the range when installed

= =

ANTI-TIP STABILITY DEVICE FIXING

(260	10"	15/64
	mm)

Anti-tip stability device

Rear right feet of range

Fig. 1.9

8