DeLonghi DL 48 P6G, DL48P6G-E Setting the Burner Minimum, Rapid, triple ring and griddle burners

F

Fig. 2.21

H

G

Fig. 2.22

SETTING THE BURNER MINIMUM

When switching from one type of gas to another, the minimum flow rate must also be correct: the flame should not go out even when passing suddenly from maximum to minimum flame.

To regulate the flame follow the instructions below:

Rapid, triple ring and griddle burners

–Light the burner

–Set the gas valve to position

–Remove the knob

–With a thin screwdriver pass by the hole of microswitch and turn the screw F until adjustment is correct (fig. 2.21).

Inside crown of DUAL burner

–Light the DUAL burner

–Set the gas valve to position

–Remove the knob

–Using a screwdriver turn the screw H until the correct setting is obtained (fig. 2.22).

Outside crowns of DUAL burner

–Light the DUAL burner

–Set the gas valve to position

–Remove the knob

–Using a screwdriver turn the screw G until the correct setting is obtained (fig. 2.22).

For LP/PROPANE gas, tighten the adjustment screws completely.

After regulation repeat the operations indicated in paragraph “2. Pressure regulator” at page 13.

If the range has been disconnected and then connected again to the gas supply line repeat the operations indicated in paragraph “5. Leak Testing” at page 16.

IMPORTANT:

After conversion to LP/PROPANE gas has been carried out affix on the back of the appliance, near the data plate, the conversion label supplied and also affix a conversion label at page 3 of this instruction manual.

22