Auto-start
You can set the
Please note!
To activate this function, the time must already have been set correctly.
To activate
1.Press the P button to enter the menu;
2.Turn the selection knob (fig. 7) until “Auto- start” is displayed;
3. Press the | button. “Activate?” is | ||
displayed; |
|
|
|
|
|
4.Press the button to confirm;
5.Turn the selection knob to choose the hours;
6. Press the | button to confirm; |
7.Turn the selection knob (fig. 7) to change the minutes;
8.Press the button to confirm;
9.Press the button to exit the menu. Once the time has been confirmed, activation
of
To deactivate the function:
1.Select
2.Press the button. “Deactivate?” is displayed;
3. | press the |
| button to confirm. | ||
The | symbol |
|
|
| is no longer displayed. |
|
|
Setting the temperature
To modify the temperature of the water used to make the coffee, proceed as follows:
1.Press the P button to enter the menu;
2.Turn the selection knob (fig. 7) until “Set temperature” is displayed;
3.Press the button;
4.Turn the selection knob until the required temperature (• = low; •••• = high) is displayed;
5. Press the | button to confirm; |
6. Press the button to exit the menu.
Energy Saving
Use this function to activate or deactivate energy saving mode. When activated, the function reduces energy consumption.
When energy saving mode is active, an asterisk appears below “Energy Saving” in the menu. EN To deactivate or activate “Energy Saving” mode, proceed as follows:
1.Press the P button to enter the menu;
2.Turn the selection knob (fig. 7) until “Energy
Saving” is displayed;
3. Press the button. “Deactivate?” is displayed, or “Active?” if the function has already been disabled.
4.Press the button to deactivate energy saving mode;
5.Then press the button to exit the
menu.
When the function is active, if the machine is not used for about 1 minute, “Energy Saving” is displayed.
Please note!
When in energy saving mode, a few seconds may elapse before the first coffee is delivered as the appliance must heat up again.
Setting water hardness
For instructions on setting water hardness, see page 19.
Setting the language
To change the language for the display, proceed as follows:
1.Press the P button to enter the menu;
2.Turn the selection knob (fig. 7) until “Set language” is displayed;
3.Press the button;
4.Turn the selection knob until the required language is displayed;
5. | Press the | button to confirm; |
6. | Press the | button to exit the menu. |
Install filter
For instructions on how to install the filter, see the section “Installing the filter” on page 19.
Replacing the filter
For instructions on how to replace the filter, see the section “Replacing the filter” on page 19.
Activate/deactivate the beep
This activates or deactivates the beep emitted by the machine each time the buttons are pressed or an accessory is inserted/removed.
11