(Making cappuccino or macchiato), pressing the CAPPUCCINO button twice instead of once.
Please note!
If during delivery you want to stop making milk or coffee, press the CAPPUCCINO button once.
Preparing milk (unfrothed and without coffee) Proceed as described in the previous paragraph (Making frothed milk), turning the froth
adjustment knob to position 1 
(fig. 20).
Cleaning the milk frother with the CLEAN button
“Press CLEAN button” flashes on the display each time you use a milk function.
To eliminate all milk residues, proceed as follows:
1.Leave the milk container in the machine (you do not need to empty it);
2.Place a cup or other recipient under the frothed milk spout.
3.Press the CLEAN button (fig. 21) and keep pressing until the progress bar which appears on the display together with the message “Cleaning...” is complete.
Please note!
•If you are making a number of cappuccinos one after the other, you do not need to clean by pressing the CLEAN button each time you make a cappuccino. Just press it once after making the last cappuccino (the appliance can continue making cappuccino or coffee even if the CLEAN button is not pressed).
•After use, always clean the hot water/steam nozzle and the milk container as described on pages
Programming the quantity of coffee and milk in the cup for cappuccino or milk
The appliance is set by default to automatically deliver standard quantities.
To change these quantities, proceed as follows:
1.Place a cup under the coffee and milk spouts.
2.Hold the CAPPUCCINO button until the message “Milk for Cappuccino Program Quantity” is displayed.
3.Release the button. The appliance starts delivering milk.
4.Once the required quantity of milk has
been delivered into the cup, press the | EN |
CAPPUCCINO button again. |
|
5.The appliance stops delivering milk and after a few seconds the coffee is delivered into the cup. “Coffee for Cappucc. Program Quantity” is displayed.
6.Once the required quantity of coffee has been delivered into the cup, press the
CAPPUCCINO button. Coffee delivery stops. The machine is now reprogrammed with the new quantities.
HEATING WATER
Important! Danger of burns.
Never leave the machine unsupervised while delivering hot water.
The spout becomes hot during delivery. Hold by the plastic handle only.
1.Make sure the hot water spout is attached correctly (fig. 4).
2.Place a container under the spout (as close as possible to avoid splashes).
3.Press the 
button (fig. 2). “Hot water…” is displayed, together with a progress bar which fills gradually as preparation proceeds.
4.The machine delivers 8.5 oz / 250 ml of hot water, then delivery stops automatically. To interrupt delivery of hot water manually,
press the 
button again.
Please note!
If “Energy Saving” mode is active, you may have to wait a few seconds before the hot water is delivered.
Change the quantity of water delivered automatically.
The machine is set by default to automatically delivery 8.5 oz / 250 ml of hot water.
To modify these quantities, proceed as follows:
1.Position a container under the spout.
2.Press the 
button again until “Hot Water Program Quantity” is displayed, then release
the 
button.
3.When the hot water in the cup reaches the
required level, press the 
button again.
The machine is now reprogrammed with the new quantity.
15
