DISPLAYED MESSAGES
DISPLAYED MESSAGE | POSSIBLE CAUSE | REMEDY |
|
|
|
FILL TANK | Insufficient water in the tank. | Fill the tank with water and/or insert it correctly, pushing it |
|
| as far as it will go until it clicks into place (fig. 3). |
GROUND TOO FINE ADJUST | The grinding is too fine and the coffee is delivered too | Repeat coffee delivery and turn the grinding adjustment |
MILL | slowly or not at all. | knob one click clockwise towards “7” while the coffee mill |
| is in operation. | |
|
| |
|
| If after making at least 2 coffees delivery is still too slow, |
|
| repeat the correction procedure, turning the Grinding |
|
| adjustment knob another click until delivery is correct. |
|
|
|
INSERT WATER SPOUT | The water spout is not inserted or is inserted incorrectly. | Insert water spout as far as it will go (fig. 4). |
|
|
|
EMPTY GROUNDS CONTAINER | The grounds container is full. | Empty the grounds container and clean, then replace. |
|
| Important: when removing the drip tray, the grounds |
| 72 hours have passed since the first coffee after the | container MUST be emptied, even if it contains few |
| grounds. If this is not done, when you make the next | |
| grounds container was last emptied. | |
| coffees, the grounds container may fill up more than | |
|
| |
|
| expected and clog the machine. (To ensure the 72 hours are |
|
| calculated correctly, the appliance must never be turned off |
|
| with the main switch in the 0 position.) |
|
|
|
INSERT GROUNDS CONTAINER | After cleaning, the grounds container has not been | Open the service door, remove the drip tray and insert the |
| replaced. | grounds container. |
ADD | The | Place |
| without placing any | |
DESCALE | The machine must be descaled. | The descaling procedure described in the “Descaling” |
|
| section needs to be performed as soon as possible. |
LESS COFFEE | Too much coffee has been used. | Select a milder taste or reduce the quantity of |
|
| coffee. |
FILL BEANS CONTAINER | The coffee beans have run out. | Fill the beans container |
|
|
|
| The | Empty the funnel as described in the section “Cleaning the |
|
| |
|
|
|
INSERT INFUSER ASSEMBLY | The infuser has not been replaced after cleaning. | Insert the infuser as described in the paragraph “Cleaning |
|
| the infuser”. |
CLOSE DOOR | The service door is open | Close the service door. |
|
|
|
INSERT MILK CONTAINER | The milk container is not inserted correctly. | Insert the milk container as far as it will go. |
|
|
|
PRESS CLEAN | Milk has been delivered recently and the tubes inside the | Press the “CLEAN” button and keep pressing until the |
| milk container must be cleaned. | progress bar is complete. “Cleaning underway” is displayed. |
Energy Saving | The function is active and reduces electricity consumption. | Disable the function from the menu (See section “Energy |
|
| Saving”). |
GENERAL ALARM | The inside of the appliance is very dirty. | Clean the inside of the appliance thoroughly, as described |
|
| in the section “Cleaning and maintenance”. If the message |
|
| is still displayed after cleaning, contact a service centre. |
|
|
|
EMPTY CIRCUIT FILL CIRCUIT | The water circuit is emtpy | Press OK button to deliver water from the spout until it |
alternating with... |
| flows out normally. |
Hot water Press OK |
|
|
18