Cleaning the drip tray
Important!
If the drip tray is not emptied regularly, the water could overflow from the edge and seep inside or around the machine.
This could damage the machine, the surface it rests on or the surrounding area.
The drip tray is fitted with a level indicator (red) showing the level of water it contains (fig. 18). Before the indicator protrudes from the cup tray, the drip tray must be emptied and cleaned.
To remove the drip tray:
1.Remove the drip tray and the grounds con- tainer (fig. 17);
2.Empty the drip tray and grounds container and wash them;
3.Replace the drip tray and grounds container.
Cleaning the inside of the machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned off (see “Turning off”) and unplugged from the mains power supply. Never immerse the coffee maker in water.
1.Check regularly (about once a month) that the inside of the appliance (accessible after removing the drip tray) is not dirty.
If necessary, remove coffee deposits with the brush supplied and a sponge.
2.Remove the residues with a vacuum cleaner (fig. 19).
Cleaning the water tank
1.Clean the water tank (A12) regularly using mild soapy water
2.Rinse the water tank thoroughly and fill the tank with fresh water and put back in the ap- pliance.
Cleaning the coffee spouts
1.Clean the coffee spouts with a sponge or cloth (fig. 21).
2.Check the holes in the coffee spout are not blocked. If necessary, remove cof- fee deposits with a toothpick (fig. 22).
Cleaning the pre-ground coffee funnel
Check regularly (about once a month ) that the
Cleaning the infuser
The infuser (A11) must be cleaned at least once a month.
Important!
The infuser must not be extracted when the ma- chine is on.
1.Make sure the machine is correctly turned off (see Turning off).
2.Open the service door
3.Extract the drip tray and the grounds contai- ner (fig. 17).
4.Press the two red release buttons inwards and at the same time pull the infuser ou- twards (fig. 22).
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER Do not use washing up liquid to clean the infuser as it could cause damage.
5.Soak the infuser in water for about 5 minu- tes, then rinse under the tap.
6.After cleaning, replace the infuser by sliding it onto the internal support and pin at the bottom, then push the PUSH symbol fully in until it clicks into place.
Please note:
If the infuser is difficult to insert, before insertion, adapt it to the right size by pressing
the two levers
shown in the figure.
7. Once inserted, make sure the two
14
