DISPLAYED MESSAGES
DISPLAYED MESSAGE | POSSIBLE CAUSE | SOLUTION |
|
|
|
| |
FILL TANK | Insufficient water in the tank. | Fill the tank with water and/or insert it | |
|
| correctly, pushing it as far as it will go until it | |
|
| clicks into place. |
|
|
|
| |
EMPTY GROUNDS CONTAINER | The grounds container (A22) is full. | Empty the grounds container and drip tray, | |
|
| clean and replace. Important: when removing | |
|
| the drip tray, the grounds container must be | |
|
| emptied, even if it is not completely full. | |
|
| If this is not done, when you make the next | |
|
| coffees, the grounds container may fill up more | |
|
| than expected and clog the machine. | |
|
|
|
|
GROUND TOO FINE ADJUST | The grinding is too fine and the coffee is | The grinding is too fine and | the coffee is |
MILL | delivered too slowly or not at all. | delivered too slowly or not at all. | |
|
| Repeat coffee delivery and turn the grinding | |
|
| adjustment dial (fig. 10) one click clockwise to- | |
|
| wards “7” while the coffee mill is in operation. | |
|
| If after making at least 2 coffees delivery is | |
|
| still too slow, repeat the correction procedure, | |
|
| turning the grinding adjustment dial another | |
|
| click until delivery is correct (see the section: | |
|
| “Adjusting the coffee mill” on page 12). If the | |
|
| problem persists, make sure the water tank is | |
|
| fully inserted, press the | button and |
|
| deliver a little water from the spout. | |
|
|
| |
INSERT GROUNDS CONTAINER | After cleaning, the grounds container has not | Remove the drip tray and insert the grounds | |
| been replaced. | container. |
|
|
|
| |
ADD | With the | Place | |
| deselect the | ||
| the funnel. |
|
|
|
|
| |
DESCALE | The machine must be descaled. | The descaling procedure described in the | |
|
| section “Descaling” needs to be performed as | |
|
| soon as possible (page 17). |
|
|
|
| |
LESS COFFEE | Too much coffee has been used. | Select a milder taste by pressing the dial | |
|
| (fig. 9) or reduce the quantity of | |
|
| coffee. |
|
|
|
|
|
FILL BEANS CONTAINER | The coffee beans have run out. | Fill the beans container (fig. 13). |
|
|
|
| |
| The | Empty the funnel with the help of a brush as | |
|
| described in the section “Cleaning the pre- | |
|
| ground coffee funnel”. |
|
|
|
| |
INSERT INFUSER ASSEMBLY | The infuser has not been replaced after | Insert the infuser as described in the | |
| cleaning. | paragraph “Cleaning the infuser”. | |
|
|
| |
INSERT TANK | The tank is not correctly in place. | Insert the tank correctly and press as far as it | |
|
| will go. |
|
|
|
|
|
20