DeLonghi PAC-A130HPE Description of the remote control, Description Of The Remote Control

Description of the remote control

DESCRIPTION OF THE REMOTE CONTROL

1Signal transmission

2Air conditioning symbol

3Dehumidifying symbol

4Fan symbol

5HEATING symbol

6SMART symbol

7Selected temperature scale indicator

8Temperature selected

9SLEEP symbol

10BOOST symbol

11Fan speed indicator

12AUTOFAN indicator

4

	6
	7
	8
10	9
12	11
13	14
	15
17	16
	18

13 Clock

14Timer 'start-up' button

15 Timer 'shut-down' symbol

26

19

20

16	ON/Standby button
		25
17	MODE button (selects the modes)
18	FAN button
19	Increase (+) and decrease (-) temperature button
			24
20	OK button
21	Timer 'shut-down' button

22°C or °F selection button

23SLEEP button

24BOOST button

25Timer 'start-up' button

26Reset button (resets the appliance to the original settings)

21

22

23

USING THE REMOTE CONTROL

✔Point the remote control at the receiver on the applian- ce. The remote control must be no more than 23 ft (7 metres) away from the appliance (wi thout obstacles between the remote control and the receiver).

✔The remote control must be handled with extreme care. Do not drop it or expose it to direct sunlight or sources of heat.

MAX 23 ft

MAX 7 metres

•This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi- tions: (1) this device may not cause harmful interference, and (2) this device must accept any inter- ference received, including interference that may cause undesired operation.

•Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable pro- tection against harmful interference in a residential installation.

•This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol- lowing measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the customer service call center or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

10