Delta 20-400 instruction manual Product Specifications, Unpacking

PRODUCT SPECIFICATIONS

Motor	1 HP, 120V
Cutting Capacity - Height	6"
Cutting Capacity - Width	13-5/8"
Minimum Blade Width	1/8"
Maximum Blade Width	3/4"
Blade Length	93-1/2"
Blade Speed - Low	1620 ft./min (490m/min.)
Blade Speed - High	3340 ft./min (990m/min)
Table Size	15-3/4" X 18-7/8"
Table T-Slot Size (DxW)	3/8" X 3/4"
Table Height From Floor	40-3/4"
Table Tilt	3° left - 45° right
Dust Port Diameter	4"
Overall Dimensions (HxWxD)	27" X 19" X 65-1/2"
Net Weight	180 Lbs.
Shipping Weight	165 Lbs.

Unpacking

Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.

Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your machine. After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.

NOTICE: The manual cover illustrates the current production model. All other illustrations contained in the manual are representative only and may not depict the actual labeling or accessories included. These are intended to illustrate technique only.

The machine is heavy, be careful when removing it from the shipping container! Failure to comply may cause serious injury and/or damage to the sander and/or property!

Your DELTA® 14" Steel Frame Band Saw comes packed in a single container. Use a safety strap to avoid tip-over when lifting machine. Check shipping carton and machine for damage before unpacking.

Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton. Always check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a clean work surface and check that all parts are present and in good condition:

Description (Quantity)

•Stand Legs (4)

•Bottom Stand Braces (4)

•Stand Top (1)

•Stand Hardware Pack (1)

•Cast Iron Work Table (1)

•Top Trunnion (1)

•93 ½" Band Saw Blade (1)

•Blade Tensioning Handle (1)

•Throat Plate (1)

•Hardware Pack (1)

Contents of Stand	Contents of Tool
Hardware Pack	Hardware Pack
• M6 X 16 Carriage Bolts (24)	• M8 X 20 Hex Bolts (8)
• M6 FLAT Washers (24)	• M6 Lock Washers (4)
• M6 HEX Nuts (24)	• M6 Flat Washers (4)
• Rubber Feet (4)	• (size) Trunnion Feed Bolt (1)
	• 8MM Flat Washer (1)
	• Table Tilt Locking Wing Nut (1)
	• M8 Flat Washers (4)
	• M8 Lock Washers (4)
	• M8 Hex Nuts (4)

8