ASSEMBLY
STAND ASSEMBLY
Refer to Figure 2
• Place top surface (A) upside down on a level surface. Attach the four legs (B) to the top using M6 X 16 carriage bolts, M6 flat washers, and M6 hex nuts.
• Attach bottom rail supports (C) using M6 X 16 carriage bolts, M6 flat washers, and M6 hex nuts.
• Place rubber feet (D) on bottom of legs. Turn assembled stand upright.
Figure 2
SECURE TABLE TO TABLE TRUNNION SYSTEM
Refer to Figure 3
•Locate the four mounting holes (A) in the upper trunnion and attach the upper trunnion to the underside of the table using four M8 X 20 hex bolts,
M6 lock washers, and M6 flat washers
• Position the table assembly so that the upper trunnion fits into the lower trunnion and the trunion feed bolt (B) extends through the slot in the lower trunnion.
NOTE: The table tilt indicator (C) on the top trunnion should align with table tilt scale (D) on the bottom trunnion.
• Secure trunnion feed bolt using an 8MM flat washer and black table tilt locking wing nut (E).
Figure 3
ATTACHING THE SAW TO THE STAND
See Figure 4.
This step requires two adults. The DELTA® 14" Steel Frame Band Saw is heavy, be careful when lifting and
handling it! Failure to comply may cause serious injury and/or damage to the machine and/or property!
Carefully lift the saw onto the assembled stand and align the four holes in base of the saw with the holes in the top of the stand. Secure saw to the stand using four M8 X 20 hex head bolts with M8 flat washer, M8 lock washer and M8 hex nut.
Figure 4
9
