Delta 28-280 ASSEMBLING BELT AND PULLEY GUARD, ASSEMBLING SWITCH

Fig. 6

Fig. 7

Fig. 8 Fig. 9

ASSEMBLING BELTAND PULLEY GUARD

Assemble the belt and pulley guard (A)to the top of the stand,

as shown inFig. 6, using the two 1/4-20 x 1/2 hex head screws,

washers and nuts (B).

ASSEMBLING SWITCH

If you purchased your band saw complete with stand and elec-

tricals, you received a switch mounted in a switch box and a

cord set connected to the motor. Assemble the switch to the

band saw arm as follows:

1. MAKE CERTAINTHE BAND SAW IS DISCONNECTED

FROM THE POWER SOURCE.

2. CAUTION:THE ON/OFFSWITCH-TO-MOTOR CORD (F)

FIG. 7, ISTIED TOVERTICAL MOUNTINGPOST (G)OPPO-

SITETHE MOTOR PULLEY. THISCABLE TIE (H) PREVENTS

THE SWITCH-TO-MOTOR CORD (F), FROM CONTACT-

ING THE BELTOR MOTOR PULLEY DURING OPERATION.

IMPORTANT:DO NOT REMOVE THIS CABLE TIE UNLESS

YOU ARE USING THE ACCESSORY #28-984 HEIGHT

ATTACHMENTWITH THE BAND SAW.

3. Remove two outer hex nuts and lock washers (A) Fig. 8,

from the two screws extending out from the back of the switch

box (B).

4. Insert two screws (C) Fig. 9, located on back of switch box,

into two holes (D) located in the band saw arm.