Delta 28-280 instruction manual Starting Stopping SAW, Locking Switch OFF Position

5.Fasten the switch box to the band saw arm using two nuts and lockwashers (A) Fig. 10, which were removed in STEP 3.

6.Remove screw and cable clamp (E) Fig. 11, from lower arm of band saw.

7.Insert switch cord (F) Fig. 12, into clamp (E) which was removed in STEP 6, and fasten switch cord (F) to band saw as shown. IMPORTANT: CHECK AND MAKE CERTAIN THE

ON/OFF SWITCH-TO-MOTOR CORD (F) FIG. 7, IS NOT CONTACTING MOTOR PULLEY OR BELT. ADJUST CORD

(F) FIG. 7, IF NECESSARY, THEN TIGHTEN CABLE TIE (H).

STARTING AND

STOPPING SAW

To start the saw, press the “START” button (K) Fig. 12. To stop the saw, press the “STOP” button (L) Fig. 12.

LOCKING SWITCH IN

THE OFF POSITION

We suggest that when the saw is not in use, the switch be locked in the “OFF” position using a padlock (M) Fig. 13, through the switch plate and “START” button (K) as shown.

A

Fig. 10

E

Fig. 11

K

L

F

E

Fig. 12

K

M

Fig. 13

6