ASSEMBLING STOCK STOP AND TABLE EXTENSIONS
1.Decide on which side of the saw table you want the stock stop (A) Fig. 5, to be, and assemble stock stop (A) onto table extension (B), as shown. NOTE: The most commonly used position of the stock stop will be on the right hand table extension, as shown.
2.Insert ends of table extension (B) Fig. 6, into the four holes on end of saw base and into the two holes of lock bracket (C), as shown. Tighten screw (D) to hold table extension in place.
3.Assemble left hand table extension (E) Fig. 7, in the same manner.
4.Fig. 8, illustrates both the right and left hand table extensions (B) and (E) assembled to the saw and the stock stop (A) assembled to the right hand table exten- sion.
A
B
Fig. 5
C B
D
Fig. 6
E
Fig. 7
A
B
E
Fig. 8
7
