Rear Leg Panel | Delta 36-441B, 36-451X guide

UNPACKING AND CLEANING Continued

	1		3
		2	4

5

7

23

6

8

22

9 11

10

13

12 15

16

18

17

21

20

19

Fig. 3

14

1.	Combination Dust Chute/Support Panel	12.	5/16" Hex Nuts (4)
2.	Motor Pulley	13.	5/16" Hex Nuts (8)
3.	Motor	14.	5/16" Lockwashers (8)
4.	Pulley Guard	15.	5/16" Flat Washers
5.	Drive Belt	16.	5/16-18 x 5/8" Hex Head Bolts (8)
6.	Spring	17.	Rubber Feet (4)
7.	Pins (2) for Mounting Motor	18.	#10-32 x 12 Screws (8)
8.	Motor Mounting Plate	19.	#10 Keps Nuts (8)
9.	5/16 Star Washers (4)	20.	#10-1/2" Sheet Metal Screws (3)
10.	5/16 Flat Washers (4)	21.	Grommet
11.	5/16-18 x 3/4" Carriage Head Screws (4)	22.	Front Leg Panel with WARNING Label
		23.	Rear Leg Panel

9

Image 9

Delta 36-441B, 36-451X instruction manual Rear Leg Panel

Contents

Contractor’s Saw Safety Guidelines Definitions General Safety RulesImportant Safety Instructions Stay ALERT, Watch What YOU are DOING, Properly Support Long or Wide workpieces Additional Safety Rules for Contractor SAW Power Connections Motor SpecificationsGrounding Instructions Volt Minimum Gauge Extension Cord Extension Cords Unpacking and Cleaning Functional DescriptionForeword Unpacking and Cleaning Rear Leg Panel SAW Assembly Assembling SAW StandAssembling SAW to Stand Disconnect Machine from the Power Source Motor AssemblyAssembling Blade Tilting Handwheel Assembling Motor to Motor Mounting Plate Assembling Motor and Motor Mounting Plate to SAW Disconnect Machine from Power Source To Motor Mounting Plate Assembling Motor PULLEY, Belt Pulley GUARD, and Drive Belt Illustrates the motor cord connected to the switch assembly Connecting Motor Cord to Switch Assembly Assembling Blade Guard Splitter Assembly Assembling and Aligning Blade Guard and Splitter Assembly If alignment is necessary, loosen the two screws Page Assembling Steel Extension Wing and Switch Model 36-441B Extension and Switch AssemblyAssembling Switch to Cast Iron Extension Wing Assembling Cast Iron Extension Operating Controls Fastening Stand to Supporting Surface Adjusting 90 Degree and 45 Degree Positive Stops Operation and AdjustmentsRaising and Lowering Blade Tilting the Blade Adjusting Blade Alignment Checking Blade AlignmentBlade Alignment Backlash Adjustments Adjusting Blade Tilting MechanismChanging SAW Blade Miter Gage Operation and Adjustment Adjusting Table Insert Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING Common Sawing OperationsCROSS-CUTTING Constructing a Push Stick Ripping Using Moulding Cutterhead Accessory Moulding Cutterhead Using Dado Head Accessory Dado Head Constructing a Featherboard Power Tool Institute Constructing a Push Stick Pushstick Storage MaintenanceDust Chute Repositioning Motor For Storage Accessories PARTS, Service or Warranty Assistance Canadian PORTER-CABLE Delta Service Centers