SAW ASSEMBLY

DO NOT OPERATE THIS MACHINE UNTIL YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL. MAKE SURE THE SAW IS SECURELY ATTACHED TO THE STAND BEFORE PERFORMING ANY CUTTING OPERATIONS.

ASSEMBLING SAW STAND

1.Assemble the dust chute and support panel (A) Fig. 4, to the inside of the front stand panel (B) with three #10 x 1/2" sheet metal screws (C).

2.Insert four #10-32 x 1/2" screws (D) Fig. 5 through support panel and dust chute. Install four #10-32 hex nuts (E) Fig. 5. IMPORTANT: The front stand panel should be assembled with the Warning Label facing the front of the saw. Do not completely tighten the stand hardware at this time. Also, make certain the dust chute/support panel (A) Fig. 5, is located under the lip of front stand panel (B) and the sheet metal screws (C) point up.

3.Assemble the other end of dust chute and support panel (A) Fig. 6, to rear stand panel (F) as shown with four #10-32 x 1/2" screws and #10-32 hex nuts, which are shown at (C). NOTE: Do not completely tighten stand hardware at this time.

E

D

 

B

 

C

 

A

Fig. 5

ASSEMBLING

SAW TO STAND

1.Turn saw table face down on a piece of cardboard to protect the table surface. Place stand (B) Fig. 7, onto saw (A). Align eight holes in the stand (B) with mounting holes in the saw (A). Fasten stand with eight 5/16"-18 bolts, flat washers, lockwashers, and hex nuts one of which is shown at (C) Fig. 7. Assemble flat washers on bolts, place bolts through holes, assemble lockwashers then hex nuts finger tight. Do not completely tighten hardware at this time.

2.Install four rubber feet (D) Fig. 7, on the end of each stand leg (B).

3.Turn saw table face up.

C

C

B

A

Fig. 4

F

C

CA

Fig. 6

D

B

C

A

Fig. 7

10

Page 10
Image 10
Delta 36-451X, 36-441B instruction manual SAW Assembly, Assembling SAW Stand, Assembling SAW to Stand