Delta 36-465 instruction manual Motor Assembly, Assembling Blade Tilting Handwheel, E F G, C B A

4.Push down on the top of the saw (E) Fig. 8 until the stand legs (F) are positioned firmly on the floor surface.

Securely tighten all saw and stand mounting hardware. Note that panel (G) is not only a support for a stand, but also serves as a dust chute.

5.Fig. 8, illustrates the saw assembled to the stand.

NOTE: If it becomes necessary to move the saw to another location, additional adjustments may be required.

ASSEMBLING BLADE

TILTING HANDWHEEL

1.Attach blade tilting handwheel (A) Fig. 9 to shaft (B). Make certain slot (C) in handwheel is engaged with roll pin (D) on the shaft.

2.Thread locking lever (E) Fig. 10, on shaft and tighten securely.

3.Fig. 10 illustrates the blade tilting handwheel (A) and locking lever (E) assembled to the saw.

E

F

G

Fig. 8

D

AC

A

E

B

Fig. 9

Fig. 10

MOTOR ASSEMBLY

The motor shipped with your saw is a 1-1/2 H.P. at 115 volts or 2 H.P. at 230 volts, Ball Bearing, Capacitor Start/Capacitor Run motor. This motor has been especially selected to best supply power to your machine, and the relative safety of the machine is enhanced by its use. Use only this motor, as the use of other motors may be detrimental to the performance and safety of the saw.

ASSEMBLING MOTOR TO

MOTOR MOUNTING PLATE

DISCONNECT MACHINE FROM THE POWER SOURCE.

1.Assemble the motor (A) to the motor mounting plate

(B) as shown in Fig. 11, using four 5/16-18 carriage bolts, flat washers, star washers, and hex nuts (C). Insert bolts through the holes in motor base and mounting plate, then assemble flat washers, then star washers, and hex nuts.

NOTE: Do not completely tighten the hex nuts at this time.

C

B

A

Fig. 11

11