A table insert blank (B) Fig. 22, is supplied as standard equipment with your scroll saw and can be used when cutting very small workpieces to give added support to the bottom of the workpiece. Simply cut a slot into the blank and replace the standard insert (A) with the blank
(B). The slot cut into the blank (B) will only be as wide as the blade giving maximum support to the bottom of the workpiece.
CHANGING BLADES
1.
WARNING: TO AVOID INJURY FROM ACCI- DENTAL STARTING ALWAYS TURN SWITCH "OFF" AND REMOVE POWER CORD PLUG FROM ELEC- TRICAL OUTLET BEFORE REMOVING OR REPLAC- ING BLADE.
2.Remove table insert (A) Fig. 23, and release blade tension by pulling tension lever (B) forward, as shown.
3.Push chuck locking lever (C) Fig. 24, to the rear as shown. This will automatically release the blade (D) from the upper chuck (E).
BA
Fig. 22
B
A
Fig. 23
E
C
D
Fig. 24
4.Insert long end (F) Fig. 25, of quickset blade chang- ing wrench into hole (G) in lower blade holder. This will
(J).
J
H
F
G
Fig. 25
10
