4.Screw threaded end of stud (H) Fig. 6, with flat washer (J) through slot in angle of tilt scale (D) and into tapped hole (K).
K
D
J
H
Fig. 6
5.Reassemble handle (G) Fig. 7, and screw and spring
(F) which were removed in STEP 3, onto stud (H). Move table (A) to the horizontal position and lock table (A), by turning handle (G) clockwise.
A
F
H
G
Fig. 7
6.Using the wrench (L) Fig. 8, supplied, loosen the two screws on bottom of bracket (M) that fasten bracket to rod (N).
7.Rotate bracket (M), to the position shown in Fig. 9. Loosen lock handle (R) and insert holddown rod (S) into hole in bracket (M), as shown.
N
M
L
Fig. 8
M S
R
Fig. 9
5
