FASTENING SCROLL SAW
TO SUPPORTING SURFACE
Your scroll saw MUST be securely fastened to a stand or workbench using the three holes in the base, two of which are shown at (A) Fig. 4.
IMPORTANT: If there is any tendency for the stand or workbench to move during operation, the stand or workbench MUST be fastened to the floor.
A
Fig. 4
ON-OFF SWITCH AND VARIABLE SPEED CONTROL
The
(B)are located on the right front side of the scroll saw base, as shown. To turn the saw “ON”, push the switch
(A)up and to turn the saw “OFF”, push the switch (A) down.
This scroll saw is supplied with variable speed control ranging from 600 to 1650 strokes per minute. Turn variable speed control (B) Fig. 5, counterclockwise to reduce speed and clockwise to increase speed.
LOCKING SWITCH IN
THE “OFF” POSITION
IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position. Grasp the switch toggle (B) Fig. 6, and pull it out as shown. With the switch toggle (B) removed, the switch, (A) Fig. 6, will not operate.
B
CCWCW
A
Fig. 5
A
B
Fig. 6
FUSE REPLACEMENT
A fuse holder (A) Fig. 6A, and fuse (B) are located under the rear of the machine and should be removed and checked if the machine does not operate. If the fuse (B) is bad, replace it with a 3 amp fuse.
BA
Fig. 6A
6
