ASSEMBLY

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

ASSEMBLING

CASTERS TO BASE

1.Insert threaded rod of caster (A) Fig. 4, into the hole located on the underside of base (B) and fasten with 3/8" lockwasher (C) and 3/8-16 hex nut (D). Fig. 5, illustrates the caster fastened to the base.

2.Assemble the remaining three casters to the underside of the base in the same manner.

AB

C

D

Fig. 4

ASSEMBLING BLOWER AND MOTOR ASSEMBLY TO BASE

1.Turn base (A) Fig. 6, right side up. Align the mounting holes at the base of blower and motor assembly (B) Fig. 6, with six pre-drilled holes (C) in base

(A) and fasten with six 5/16-18x5/8" hex head screws (D) and 5/16" lockwashers (E).

2.Fig. 7, illustrates the blower and motor assembly (B) fastened to base (A).

3.Assemble drum support (F) Fig. 8, to the two threaded holes in the corner of base (A), as shown in Fig. 8, with two 5/16-18x5/8" hex head screws and 5/16" lockwashers (G). NOTE: Do not completely tighten hardware at this time.

Fig. 5

A

C B

D

C

E

B

A

Fig. 6

F

G G

A

Fig. 7

Fig. 8

5

Page 5
Image 5
Delta 50-850 instruction manual Assembling Casters to Base, Assembling Blower and Motor Assembly to Base