4.Assemble the remaining drum supports (F) Fig. 9, to base (A) as shown.
5.Assemble “U” bracket (H) Fig. 10, to drum (J). Place a 5/16" flat washer then a 5/16" lockwasher onto a 5/16- 18x5/8" hex head screw. Insert the hex head screw (K) thru the hole in the “U” bracket and the hole in the drum, thread a 5/16" hex nut onto the hex head screw and tighten securely. Repeat this process for the remaining hole. NOTE: “U” bracket should be mounted to the right side of opening (L) in drum as shown.
6.Align the holes in the drum support (M) Fig. 12, with the holes in the drum (J). Place a 5/16" flat washer on a
7.The dust collector is supplied with two 6" hose clamps (P) Fig. 13. Place one end of 6" dia. flexible hose
(R) over blower/motor inlet (B) Fig. 14, and secure with hose clamp (P).
8.Place the other 6" hose clamp on flexible hose and attach the other end of the hose to drum (J) Fig. 14 in the same manner.
P
F
F
A
Fig. 9
J
H
K
L
Fig. 10
J
M
M 
Fig. 12
J
R
P
Fig. 13
P
B
Fig. 14
R
6
