Delta 50-850 instruction manual

9.Attach the lower dust bag retaining clip (A) Fig. 14A, to the dust collector drum. Align the two holes (B) in the retaining clip (A) Fig. 14A, with the two holes in the drum. Insert a 1/4-20x5/8" hex head screw through the holes in the retaining clip and the holes in the drum. Place a 1/4" flat washer onto the screws, and thread 1/4-20 hex nut s on the screws and tighten securely. Repeat this process for the three remaining sides of the drum.

ASSEMBLING DUST INTAKE PORT AND CAPS TO BLOWER AND MOTOR ASSEMBLY

1.MAKE CERTAIN THE DUST COLLECTOR IS DISCONNECTED FROM THE POWER SOURCE.

2.Align the four holes in dust intake port (A) Fig. 15, with the mounting holes in flange (B) of blower and motor assembly and fasten with four sheet metal screws

(C). Fig. 16 illustrates the dust intake port assembled to the blower assembly.

3.NOTE: Two dust intake port caps (D) Fig. 17, are supplied with the dust collector. The caps are to be placed into the dust intake ports (E) when the intake ports are not in use.

4.Place the collar of dust cap (D) Fig. 17, over the opening on intake port. Press recessed side of dust cap

(D) into port opening. IMPORTANT: When connecting an intake hose to one or both intake ports, DO NOT

REMOVE THE DUST CAP COLLARS (F) FIG. 17 FROM THE INTAKE PORTS. Pull the dust cap from the port opening and slide the collar and cap farther onto the port housing.

B

A

Fig. 14A

B

A

C

Fig. 15

Fig. 16

E

F

D

E

D

Fig. 17

7