CONNECTING MACHINE TO POWER SOURCE
MODEL
SINGLE PHASE
INSTALLATION
WARNING: Installation by a qualified electrician is recommended to assure safe and proper wiring and product operation.
The motor rating for your single phase dust collector is 230 Volts, 5 H.P. Before connecting your dust collector to an electrical power system, be sure the electrical system agrees with the motor rating of the tool.
The single phase Model
1.Assemble the control box (A) Fig. 32, to the front of the side support (H) Fig. 33. Insert sheet metal screws
(B) Fig. 32, through holes in the controller box and thread the sheet metal screw into the side support and tighten securely.
2.Bring the power cord (not supplied) up through the large knockout hole (C) Fig. 32, in the control box (A) and connect the two power lines to terminals (D) and the green ground wire to ground screw (E). NOTE: THE
POWER CORD MUST BE INSERTED THROUGH THE BUSHING IN THE ACCESS HOLE (C), TIGHTEN THE ACCESS HOLE NUT OVER THE ACCESS HOLE TO HOLD THE POWER CORD IN PLACE.
3.Reassemble the cover onto the controller box (A) Fig. 33.
4.The ON/OFF buttons are located at the front of the control box. To start the machine, push “ON” button (F) Fig. 33. To stop the machine, push the “OFF” button (G).
B
D
D
E
B
A
C
Fig. 32
H
F
A
G
Fig. 33
12