3. Assemble |
(G) Fig. 23, to the top half of the upper bag support (H). |
Place a 5/16" lockwasher (I) onto a |
head screw (J), place a special washer (K) (30mm O.D., |
8mm I.D., 3mm thick), onto the screw, insert the screw |
through the filter bag hanger and place special washer |
(L) (30mm O.D., 8mm I.D., 3mm thick) onto screw. |
GH
J
Thread the screw into the top half of upper bag support. |
Assemble the remaining |
upper bag support (H) in the same manner. |
I
J
L
H
G
K
Fig. 23
4. Insert the upper bag support (H) Fig. 24, into the |
lower bag support (H), making certain the pin (F) in lower |
bag support engages hole in upper bag support. |
Assemble the remaining bag support in the same |
G
G
manner. |
5. Position top of filter bags (J) Fig. 24, onto both hanger |
assemblies (G) as shown, until all twelve filter bags are |
positioned (6 each) on both hanger assemblies. |
H
J
J
F
6.IMPORTANT: Each filter bag (J) Fig. 25, features a channel (K) in the hem of the bag. This will allow the filter bag (J) to be positioned and held inside the lip of six holes in each drum assembly (B). Insert the open end of each bag (J) Fig. 26, into the hole in the drum assembly until the channel (K) in the bag is positioned over the lip of each drum opening as shown. Assemble the remaining 11 filter bags to the two drums in the same manner.
A
Fig. 24
J
K
B
Fig. 25
J
K
B
Fig. 26
10