Delta D29382 instruction manual Starting Your Pressure Washer

6.Connect the high pressure hose (i) to the water outlet on the unit. The water outlet is marked OUT.

7.Assemble quick-connect adapter (k) to water inlet.

i

k

8.Connect the quick-connect (j) to the water supply hose.

9.Connect quick-connect (j) to quick connect adapter (k) at the water inlet.

j

k j

NOTE: The water supply must provide a minimum of 5 gallons per minute.

10.Make sure high pressure hose and water supply hose are securely connected.

11.Connect the desired nozzle to spray wand. To connect rotary (a) and variable spray nozzle (b), turn clockwise until it snaps into place. To remove nozzle, turn nozzle counter clockwise to remove. To connect chemical application unit (c) see

How To Use Cleaning Solution Application Unit in this section.

12.Turn water supply on.

a

b

c

STARTING YOUR PRESSURE WASHER

NOTE: Make sure water supply is turned on.

1.Disengage the safety catch as shown.

Depress trigger to allow air to escape and to discharge residual pressure in the pipes.

2. With the trigger depressed, place the ON- OFF switch in the On position. When starting motor, always keep the trigger depressed.

If after running unit for a few minutes it does not maintain steady water pressure, turn unit off to prevent damage to the

unit and see the troubleshooting guide for instructions.

D29382 12- ENG