Delta D29382 How To Use Spray Wand, How To Use The Cleaning Solution Application Unit

Models: D29382

1 18
Download 18 pages 41.6 Kb
Page 9
Image 9
HOW TO USE

Total Stop System: This unit is equipped with a total stop system. When the trigger is released the motor is shut off automatically. When the trigger is pressed again the motor will automatically start. The time between release and engage- ment must not be less than 4-5 seconds. DO NOT leave the unit in automatic stop mode for more than 15 minutes.

psi: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc.

GPM: Gallons Per Minute. The unit of measure for the flow rate of water through the pressure washer.

CU: Cleaning Units. GPM multiplied by psi.

Water Supply: All pressure washers must have a source of water. The minimum requirements for a water supply are 20 psi and 5 gallons per minute.

HOW TO USE

IMPORTANT: Read and understand how to use the pressure washer before operating.

HOW TO USE SPRAY WAND

The nozzle at the end of the wand can be rotated to change from narrow jet stream to fan jet, as shown.

jet stream

fan spray

HOW TO USE THE CLEANING SOLUTION APPLICATION UNIT

NOTE: Use only soaps and cleaning solutions designed for pressure washer use. Do not use bleach.

1.Place the ON-OFF switch in the OFF position.

2.Turn off the water supply.

3.Attach cleaning solution application unit to wand as shown and tighten securely. Grasp end of nozzle and turn until cleaning solution application unit is oriented correctly.

9- ENG

D29382

Page 9
Image 9
Delta D29382 instruction manual How To Use Spray Wand, How To Use The Cleaning Solution Application Unit