Delta DBN125, DNS100, DBS125 EMPLOYER’S Responsibilities, Functional Description, Power Source

EMPLOYER’S RESPONSIBILITIES

Employer must enforce compliance with the safety warnings and all other instructions contained in this manual.

Keep this manual available for use by all people assigned to use this tool.

For personal safety and proper operation of this tool, read and understand tool labels and manual. Failure to follow warnings could result in DEATH or SERIOUS INJURY. Read and follow all of these instructions carefully.

FUNCTIONAL DESCRIPTION

Delta Model DBN125 is designed to install 18 ga. brad nails of various lengths from 3/ 8" to 11/4" long. Brad nails are loaded into the magazine from the side.

Delta Model DBS125 is designed as a 2 in 1 tool to install 18 ga. brad nails of various lengths from 3/ 8" to 11/4" long and narrow crown staples of various lengths from 3/ 8" to 1" long. Brad nails are loaded into the magazine from the side and narrow crown staples are loaded into the magazine from the top.

Delta Model DNS100 is designed to install 18 ga. narrow crown staples of various lengths from 3/ 8" to 1" long. Narrow crown staples are loaded into the magazine from the top.

Delta ShopMaster nailing and stapling tools are compact, lightweight, high performance tools designed for molding, interior trim, paneling, cabinetry, picture/mirror frames and crafts. Features include jam release mechanism, tool free adjustable exhaust and fastener depth adjustments, fastener reload indicator, rubber grip, safety positioned on rear of nose and a removable rubber nose cushion with on tool storage.

Use approved Delta fasteners only.

POWER SOURCE

This tool is designed to operate on clean, dry, compressed air at regulated pressures between 70 and 120 PSI (Pounds per Square Inch)(4.8 to 8.3 BAR). The preferred system would include a filter, a pressure regulator, and an automatic oiler located as close to the tool as possible, within 15 ft/4.6 m is ideal.

All compressed air contains moisture and other contaminates that are detrimental to internal components of the tool. An air line filter will remove most of these contaminates and significantly prolong the life of the tool. If an in-line oiler is not available: place five or six drops of Delta Air Tool Oil into the tool’s air inlet at the beginning of each workday.

The tool is equipped with a 1/4" male “quick connector”. The tool must always be connected to the air supply with a coupling such that all pressure is removed from the tool when the coupling is disconnected.

7