TROUBLESHOOTING
Disconnect tool from air supply before performing any Service Procedure.
SYMPTOM | PROBLEMS | SOLUTIONS |
1.Air leak near top of tool or in trigger area.
Loose screws. | Tighten screws. |
Worn or damaged | Install Overhaul Kit. |
|
2.Tool does nothing or operates sluggishly.
Inadequate air supply. | Verify adequate air supply. |
Inadequate lubrication. | Put 5 or 6 drops of oil into air inlet. |
Worn or damaged | Install Overhaul Kit. |
|
3.Air leak near bottom of tool.
Loose screws. | Tighten screws. |
Worn or damaged | Install Overhaul Kit. |
|
4. | Tool jams frequently. | Incorrect fasteners. | Verify approved fasteners of |
|
|
| correct size. |
|
| Damaged fasteners. | Replace w/undamaged fasteners. |
|
| Magazine or nose | Tighten screws. |
|
| screws loose. |
|
|
| Magazine is dirty. | Clean magazine. |
|
| Driver is worn or damaged. | Install “DRIVER” Maintenance Kit. |
|
|
|
|
5. | Other. |
| Contact a |
|
|
| Service Facility. |
13
