TROUBLE SHOOTING GUIDE
PROBLEM | CAUSE | CORRECTION | |||
|
|
|
|
| |
|
| No fuel. | Add Fuel. | ||
Engine will not | |||||
|
|
| |||
Pressure builds up after two pulls on | Squeeze gun trigger to relieve | ||||
start (see Engine | |||||
Manual for | the recoil starter or after initial use. | pressure. | |||
further engine |
| Engine not primed | Push primer button three times | ||
troubleshooting) |
|
|
|
| |
| Spark plug wire not attached. | Attach spark plug wire. | |||
|
| ||||
No or low |
| ||||
|
|
|
| ||
| Spray wand not in high pressure. | See How to Use Spray Wand | |||
pressure |
|
| instructions in the Operation | ||
(initial use) |
|
| Section. | ||
|
| Low water supply. | Water supply must be at least 5 | ||
|
|
| GPM @ 20 PSI. | ||
|
| Leak at high pressure hose fitting. | Repair leak. Apply sealant tape | ||
|
|
| if necessary. | ||
|
| Nozzle obstructed. | See Nozzle Cleaning instructions | ||
|
|
| in the Maintenance section. | ||
|
|
|
|
| |
|
| Water filter screen clogged. | Remove and clean filter. |
| |
|
|
|
|
| |
|
| Air in hose. | Turn off the engine, then the | ||
|
|
| water source. Disconnect the | ||
|
|
| water source from the pump inlet | ||
|
|
| and turn the water source on to | ||
|
|
| remove all air from the hose. | ||
|
|
| When there is a steady stream of | ||
|
|
| water present, turn water source | ||
|
|
| off. | ||
|
|
| pump inlet and turn on water | ||
|
|
| source. Squeeze trigger to re- | ||
|
|
| move remaining air. | ||
|
|
|
|
| |
|
| Throttle control lever is not in the | Move throttle control lever to the | ||
|
| “Fast” position. | “Fast” position. | ||
|
| High pressure hose is too long. | Use high pressure hose under | ||
|
|
| 100 feet. | ||
|
|
|
|
| |
Will not draw | Spray wand not in low pressure. | See How to Use Spray Wand |
| ||
| paragraph in the Operation |
| |||
chemicals |
|
| |||
| Section. |
| |||
|
|
|
| ||
|
|
|
|
| |
|
| Chemical filter clogged. | Clean filter. | ||
|
|
|
|
| |
|
| Chemical screen not in cleaning | Make sure end of chemical hose | ||
|
| solution. | is fully submerged into cleaning |
| |
|
|
| solution. |
| |
|
| Chemical too thick. | Dilute chemical. Chemical should | ||
|
|
| be the same consistency as water. | ||
|
|
|
|
| |
|
| Pressure hose is too long | Lengthen water supply hose | ||
|
|
| instead of high pressure hose. | ||
|
| Chemical build up in chemical | Have parts cleaned or replaced | ||
|
| injector. | by AWSC. | ||
|
|
|
|
|
13- ENG | A04032 |