Manuals / Brands / Power Tools / Cordless Saw / Delta / Power Tools / Cordless Saw

Delta MS275 FASTENING THE MACHINE TO THE SUPPORTING SURFACE, REAR SUPPORT/STABILIZER & CARRYING HANDLE

1 21

Download 21 pages, 1.97 Mb

FASTENING THE MACHINE TO THE SUPPORTING SURFACE

Before operating your compound miter saw, mount it to

a sturdy workbench or other supporting surface. Four

holes are provided, two of which are shown at (A) Fig. 5.

When frequently moving the saw from place to place,

mount the saw to a 3/4″piece of plywood. The tool can

then be easily moved from place to place and the

plywood can be clamped to a supporting surface using

“C” clamps.

Fig. 5

REAR SUPPORT/STABILIZER & CARRYING HANDLE

Keep the rear support (A) Fig. 6 fully

extended during all cutting operations.

Push the rear support in only when

storing the machine.

Fig. 7

Fig. 6

Carrying the machine by the switch

handle will cause misalignment.

Always lift and carry the machine by

the base or by the carrying handle

(A) Fig. 7.

Use the rear support/stabilizer and carrying handle (A)

Fig. 7 to carry the machine.

Contents

Main TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS SAFETY GUIDELINES - DEFINITIONS CALIFORNIA PROPOSITION 65 GENERAL SAFETY RULES ADDITIONAL SPECIFIC SAFETY RULES 5 FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY. POWER CONNECTIONS MOTOR SPECIFICATIONS GROUNDING INSTRUCTIONS EXTENSION CORDS MINIMUM GAUGE EXTENSION CORD CARTON CONTENTS ROTATING THE TABLE Fig. 2 Fig. 3 UNPACKING AND CLEANING ASSEMBLY ASSEMBLY TOOLS REQUIRED ASSEMBLY TIME ESTIMATE - 15 to 30 minutes MOVING THE CUTTINGHEAD TO THE "UP" POSITION Fig. 4 FASTENING THE MACHINE TO THE SUPPORTING SURFACE Fig. 5 Fig. 6 REAR SUPPORT/STABILIZER & CARRYING HANDLE Fig. 7 TABLE EXTENSION WINGS DUST BAG WORK CLAMP OPERATION OPERATIONAL CONTROLS AND ADJUSTMENTS STARTING AND STOPPING THE MITER SAW Fig. 14 Fig. 15 LOCKING THE SWITCH IN THE OFF POSITION TILTING THE CUTTINGHEAD FOR BEVEL CUTTING Fig. 20 Fig. 19 ADJUSTING THE DOWNWARD TRAVEL OF THE SAW BLADE Fig. 25 ADJUSTING THE 90 AND 45 BEVEL STOPS Fig. 21 Fig. 22 Fig. 23 Fig. 24 ADJUSTING THE TABLE POSITIVE STOPS HAZARD ZONE MACHINE USE Fig. 28 Fig. 29 AUXILIARY WOOD FENCE Fig. 31 Fig. 41 Fig. 42 WORK SUPPORT EXTENSIONS CUTTING BOWED MATERIAL GENERAL CUTTING OPERATIONS RIGHT WRONG CUTTING ALUMINUM CUTTING CROWN MOULDING 45-45 CROWN MOULDING OTHER ANGLES Fig. 46 Fig. 47 MAINTENANCE Fig. 44 Fig. 45 CHANGING THE BLADE TROUBLESHOOTING BRUSH INSPECTION AND REPLACEMENT PARTS, SERVICE OR WARRANTY ASSISTANCE SERVICE ACCESSORIES WARRANTY Two Year Limited New Product Warranty The following are trademarks of PORTER-CABLE PORTER-CABLE DELTA SERVICE CENTERS (CENTROS DE SERVICIO DE PORTER-CABLE DELTA) Delta ms cercano. Delta deben obtenerse ponindose en contacto con cualquier distribuidor Porter-Cable Delta products should be obtained by contacting any Porter-Cable Delta Distributor, Authorized Service Center, or Porter-Cable