REPLACING
SANDING BELT
1.DISCONNECT MACHINE FROM POWER SOURCE.
2.Loosen screw (A) Fig. 40, and remove backstop (B).
3.Slide tension lever (C) Fig. 41, to the right to release tension on sanding belt and remove sanding belt (D) from both sanding drums, as shown.
4.Slide new sanding belt over both sanding drums making sure the belt will run in the direction of the arrow located on the inside of the belt.
5.
6.Replace backstop which was removed in STEP 2.
7.Connect electrical power to the sander and check to see if the belt is tracking properly. If not, refer to the section “TRACKING THE SANDING BELT”.
REPLACING
SANDING DISC
When it becomes necessary to replace the sanding disc, proceed as follows:
1.DISCONNECT MACHINE FROM POWER SOURCE.
2.Loosen screw (A) Fig. 42, and remove table assembly (B).
3.Remove three screws (C) Fig. 43, and lower cover
(D).
B
A
Fig. 40
D
C
Fig. 41
B
A
Fig. 42
D
C
Fig. 43
16
