Delta SA446 instruction manual Assembling Belt Pulley Guard, Assembling Sanding Disc Plate

ASSEMBLING BELT

AND PULLEY GUARD

Assemble the belt and pulley guard (A) Fig. 5, to the machine base using the two M6x1x30mm cheese head screws (B), as shown.

ASSEMBLING SANDING DISC PLATE

1.Back the 1/4-20x1/4" hex socket set screw (A) Fig. 6, out of the hole, just enough so that the set screw is not extending into hole (B) Fig. 6, in the sanding plate.

A

B

Fig. 5

B

A

2.Slide sanding disc plate (B) Fig. 7, on drive shaft (C) making sure flat on drive shaft is aligned with set screw

(A) in hub of plate (B). Slide plate (B) onto shaft (C) until plate surface and shaft are nearly flush. Shaft must not extend out past surface of plate.

B

Fig. 6

C

3.Insert the 1/8" hex wrench (D) Fig. 8, down through slot in the back of belt and pulley guard and tighten set screw against flat on shaft.

A

Fig. 7

D

Fig. 8

8