Delta SA446 instruction manual Fastening Sander to Supporting Surface, Assembling Dust Chute

ASSEMBLING DUST CHUTE

Align the three holes in the dust chute (A) Fig. 13 with the three holes in the left side of the sanding base. Place a M5.3 flat washer onto a M5x.08x10mm pan head screw

(B)Fig. 13, and insert screw through hole in dust spout and thread into taped hole in sander base. Repeat this process for the two remaining holes.

B

A

Fig. 13

ASSEMBLING BACKSTOP TO SANDING ARM

Assemble backstop (A) Fig. 14, to the sanding arm using the 1/4-20x1/2" hex head screw (B) and 5/16" flat washer (C).

WARNING: TO AVOID TRAPPING THE WORK OR FINGERS BETWEEN THE BACKSTOP AND SANDING BELT, THE EDGE (D) OF THE BACKSTOP SHOULD BE POSITIONED A MAXIMUM OF 1/16 INCH AWAY FROM SANDING BELT (E).

A

D

C

EB

Fig. 14

FASTENING SANDER TO SUPPORTING SURFACE

1.If your sander is to be used in a permanent location, it should be fastened securely to a firm supporting surface, such as a stand or workbench using the four holes, three of which are shown at (A) Fig. 15.

2.The diagram, shown in Fig. 16, illustrates the size and center to center distance of the holes to be drilled in the stand or workbench.

AA

Fig. 15

Fig. 16

10