Delta TP305 instruction manual These knobs were removed in Step

4.Insert knife transfer tool (G) Fig. 21, underneath center of knife. Lift the knife transfer tool up until knife (H) separates from pins (J) and pull out and remove knife as shown. NOTE: Knife transfer tool is magnetized, allowing it to attach to knife.

5.Rotate knife (H) Fig. 22 end-for-end, or using a new knife, position knife transfer tool (G) on top of knife as shown. Place knife in cutterhead with bevel up underneath locking bar (D), making sure pins (J) in cutterhead engage with holes (K) in knife.

6.Remove knife transfer tool and tighten the six screws at (F) Fig. 23, using wrench (E) supplied.

7.Replace other knife by rotating head 180 degrees and repeat STEPS 3 THROUGH 6.

Fig. 21

	J
G	H
Fig. 22
	K
	D
	J
	H
	G
Fig. 23	E
F	F

8.Slide cutterhead guard (B) Fig. 25 in as far as possible and replace two knobs, one of which is shown at

(A) Fig. 25. These knobs were removed in STEP 2.

Fig. 25

A

B

13