

Getting Started Connections Playback Remote Control Multi-Zone Information Troubleshooting Specifications

s XLR Out Polarity

Set to switch the XLR pre-out terminal polarity.

d POA Setting

Set when connecting the receiver to a POA-A1HDCI.

POA LINK

Set when connecting the receiver to a POA-A1HDCI through a
CONTROL LINK.
[Selectable items] OFF ON (Single) ON (Dual)
[Selectable channels]
Front L Front R Center Surround A L Surround A R
Surround B L Surround B R Surround Back L
Surround Back R Subwoofer 1 Subwoofer 2 Subwoofer 3
[Selectable items] XLR qGROUND
wHOT
eCOLD
XLR (INV) qGROUND
wCOLD
eHOT

g

Source Delete

Remove input sources that are not used from the display.
[Selectable items] ON Delete
NOTE
Input sources being used in the various zones cannot be deleted.
Input sources set to “Delete” cannot be selected from GUI menu
“Source Select” or using the SOURCE SELECT knob on the main unit
or SOURCE SELECT button on the remote control unit.

h GUI

Make GUI related settings.

Screensaver

Make screensaver settings.
Use the screensaver to prevent burn-in on the monitor screen.
When set to “ON”, the screensaver is activated if there is no activity
for about 3 minutes.
[Selectable items] ON OFF

Wall Paper

Change the GUI background.
[Selectable items] Picture Black Gray Blue

Format

Select the video output signal format to match the monitor.
[Selectable items] NTSC PAL
NOTE
When a format other than the video format of the connected monitor
is set, the picture will not be displayed properly. Use the procedure
described below to change the video format.

f Volume Control

Set the MAIN ZONE volume setting.

Volume Limit

Make a setting for maximum volume.
[Selectable items] OFF –20dB –10dB 0dB

Power On Level

This sets the volume set when the MAIN ZONE’s power is turned
on.
[Selectable items] Last – – –dB –80dB ~ 18dB

Mute Level

This sets the amount of attenuation of the volume when the mute
mode is set in the MAIN ZONE.
[Selectable items] Full –40dB –20dB

POA 1/POA 2

Set POA-A1HDCI for which the MODE select switch is set to “1” or
“2”.

LINK Check

Check CONTROL LINK.
n Input Selector
Select the setup channel.
[Selectable items] L1 R1 L2 R2 L3 R3
L4 R4 L5 R5
Select the connector input to be used for each channel.
[Selectable items] RCA XLR OFF
n Power Amp
Select the setup channel.
[Selectable items] L1/L2 L3/L4 L5/R5 R1/R2 R3/R4
Set the power amp usage for each channel.
[Selectable items] NORMAL BI-AMP BRIDGE (BTL)
See the POA-A1HDCI operating instructions.
Setup