

Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting Specifications
1Either turn <SOURCE SELECT> or press [SAT TU]

(AMP mode) to select “XM”.

: ”Source Select” (vpage 45)
2To operate using the main remote control unit, set the
remote control unit to the TUNER ( ) mode.
(vpage 77 “Remote Control Unit Operations”)
3Use [d f] to select the channel.
When the channel is tuned in, the name of the song and artist
are displayed.
• The channel switches continuously when [d f] is pressed and held.
• XM Radio channels can be preset using the same procedure as for
FM/AM stations (vpage 59, 60 “Presetting Radio Stations (Preset
Memory)” and “Listening to Preset Stations”).
• The artist name, song title, category and reception level can be
checked by pressing <STATUS>.
• The time for which the GUI menus are displayed can be set at
GUI menu “Manual Setup” – “Option Setup” – “GUI” – “Tuner”
(vpage 42).

Basic Operation Checking the XM Signal Strength and

Radio ID

1Either turn <SOURCE SELECT> or press [SAT TU]

(AMP mode) to select “XM”.

2Press <STATUS> until “SIGNAL” appears on the

display.

The display will switch as shown below, depending on the
reception conditions.
Display GUI Status
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is weak
NO No signal
3Adjust the position of the antenna until “SIGNAL:

GOOD” is shown on the display.

4Press <STATUS> until the channel (example:

“XM001”) is displayed.

5Press [d f] and select channel 0 (XM000).
The radio ID is shown on the display.
The strength of both the XM satellite and terrestrial signals can be
checked at GUI menu “Source Select” – “XM” – “Antenna Aiming”
(vpage 49).
Radio ID

Accessing XM Radio Channels Directly

1Press [SEARCH].
2Press [NUMBER] then input the channel.
Example: Accessing channel “XM123”:
[1] → [2] → [3]
b If no button is pressed within several seconds, the channel
automatically switches to the one whose number has been input.
3Press ENTER to set that channel.
Reception switches to the selected channel.
• “LOADING” is displayed while channels or data are being received.
• “XM - - -” is displayed if the selected channel cannot be used.

Searching Categories

1Press o p.
2Use o p to select the category, then use ui to select

the desired channel.

Channel category
Playback