Advanced Setup – Part 1

Setting the Dolby Digital Downmix Option Setup

Turn the audio compression on or off when down-mixing Dolby Digital signals.

1 Press D H to select “Dolby Digital Setup”, then press ENTER.

2 Press F G to set.

ON:

The dynamic range is compressed automatically according to the combination of speakers being used.

Set “Compression” to “ON” if it seems that sound is distorted because the input level exceeds the allowable input for the front speakers.

OFF:

The dynamic range is not compressed.

Normally using in this mode.

3 Press ENTER.

1

2

•When a center speaker or surround speakers are not connected, the sounds in those channels are directed to the front speakers.

Setting the Auto Surround Mode

Set whether or not to store the surround mode last played for the input signal.

The surround mode used at last for the 4 types of input signals shown below is stored in the memory, and the signal is automatically played with that surround mode the next time it is input.

qAnalog and PCM 2-channel signals (STEREO)

w2-channel signals of Dolby Digital, DTS or other multi- channel format (DOLBY PLIIx Cinema)

eMulti-channel signals of Dolby Digital, DTS or other multi- channel format (DOLBY/DTS SURROUND)

rPCM multi-channel signals other than Dolby Digital and

DTS (MULTI CH IN)

Default settings are indicated in ( ).

During playback in the PURE DIRECT mode, the surround mode does not change even if the input signal is changed.

1 Press D H to select “Auto Surround Mode”, then press ENTER.

2 Press F G to set.

3 Press ENTER.

1

2

53

ENGLISH

Advanced Setup – Part 1

Setting the Manual Equalizer Setup

Adjust the tone of the various speakers while listening to the playback signals.

1 Press D H to select “Manual EQ Setup”, then press ENTER.

2 Press F G to set, then press ENTER.

All CH:

All channels can be adjusted simultaneously.

L/R CH:

The left and right channels of the pair of speakers can be adjusted simultaneously.

Each CH:

The channels can be adjusted separately.

3 Press F G to select the speaker.

The display changes as follows.

qSelect “L/R CH”

FL/FR C

SBL/SBR SL/SR

wSelect “Each CH”

FL FR C

(2 speakers)

SBR SBL SR SL

SB

(1 speaker)

eSelect “All CH”

In this case, speaker selection is not performed.

4 Press D H to select the frequency, then press F G to adjust.

The level of the various frequencies can be adjusted between –20 dB and +6 dB.

5 Press ENTER.

ENGLISH