STEP 3
Measurement (2nd – 8th)
•In STEP 3, you will perform measurements at multiple positions (two to eight positions) other than the main listening position.
•Just one position can be measured but measuring multiple positions increases the accuracy of the correction of acoustic distortion within the listening area.
9 Move the setup microphone to position 2, use ui to select “Measure”, and then press
ENTER.
The measurement of the second position starts. Measurements can be made in up to eight positions.
AUDYSSEY AUTO SETUP
STEP3 Measurement (2nd) | 1 2 3 4 5 6 |
Please place the microphone at ear |
|
height at 2nd Iistening position. |
|
Measure |
|
Next Calculation |
|
Enter | RETURN Cancel |
Start measurement. Output large test tone during measuring
If you want to omit measurements from the next position onward, select “Next
Calculation”.
(Go to STEP4 Calculation )
10Repeat step 9, measuring positions 3 to 8.
When measurement of position 8 is completed, a “Measurements finished.” message is displayed.
AUDYSSEY AUTO SETUP
STEP3 Measurement (Finish) | 1 2 3 4 5 6 | ||||
Measurements finished. |
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Retry
Next 
Calculation
Enter RETURN Cancel
Proceed to next (Calculation)
Set up speakers (Audyssey® Auto Setup)
STEP 4
Calculation
11On the STEP 3 screen, use ui to select “Next →
Calculation”, and then press ENTER.
Measuring results are analyzed, and the frequency response of each speaker in the listening room is determined.
AUDYSSEY AUTO SETUP
STEP4 Calculation | 1 2 3 4 5 6 |
Now calculating...Please wait. 20%
•Analysis takes several minutes to complete. The time required for this analysis depends on the number of speakers connected.
The more connected speakers there are, the longer it takes to perform analysis.
vSee overleaf
version Basic
version Advanced
Information
24