ENGLISH

StartedGetting

<SOURCE SELECT>

STATUS ui

 

Connections

 

 

Setup

<ON/STANDBY>

op

Playback

[Front]

[CHANNEL +/–]

 

 

Remote

[1]

[2]

Control

 

 

 

Information

[6], [7]

 

[8], [9]

 

 

 

 

 

[ENTER]

Troubleshooting

uiop

STATUS

 

 

 

 

[MODE

[MODE

 

SELECTOR 1]

SELECTOR 2]

 

[Rear]

 

 

 

[iPod]

 

[MODE]

[ENTER]

 

uiop

 

 

About the button names in these explanations

<> : Buttons on the main unit

[ ] : Buttons on the remote control unit

Button name only:

Buttons on the main unit and remote control unit

Searching Categories

1Press op.

CAT: Rock Channel category

2Use opto select the category, then use uito select the desired station.

•“LOADING” is displayed while stations or data are being received.

•“UPDATING” is displayed while the encording code is being updated.

•“XM – – –” is displayed if the selected channel cannot be used.

iPod® Playback

The music on an iPod can be played by using the Control Dock for iPod (ASD-1R, sold separately).

The operation can also be performed using the buttons on the remote control unit.

iPod is a trademark of Apple Inc., registered in the U.S.

and other countries.

b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation.

Basic Operation

1Make the necessary preparations.

qSet the iPod in the DENON Control Dock for iPod. (vSee the Control Dock for iPod’s operating instructions.)

wAssign the Control Dock for iPod’s input.

”System Setup” – ”Input Setup” – ”iPod Assign”

(vpage 22)

2Either turn <SOURCE SELECT> or press [iPod] to select the input source assigned in step 1-wabove.

Remote iPod

bIf the displays above are not displayed, the iPod may not be properly connected. Try connecting again.

3Set [MODE SELECTOR 1] to “AUDIO” and [MODESELECTOR 2] to “iPod/NETWORK”.

(vpage 37 “Remote Control Unit Operations”)

•With the default settings, the iPod can be used connected to the VCR (iPod) connector.

•Use the RESTORER mode to expand the low and high frequency components of compressed audio files and achieve a richer sound. The default setting is “Mode3”.

•Press <ON/STANDBY> and set the AVR-488’s power to the standby mode before disconnecting the iPod. Also switch the input source to one to which “iPod Assign” is not assigned before disconnecting the iPod.

NOTE

•Depending on the type of iPod and the software version, some functions may not operate.

•DENON will accept no responsibility whatsoever for any loss of iPod data.