ENGLISH

7

a. If the “Auto” mode is selected:

Test tones are automatically emitted from the different speakers.

The test tones are emitted from the different speakers in the following order, at 4-second intervals the first time and second time around, 2- second intervals the third time around and on:

 

1

FL

1

C

1

FR

1

SR

1

SL

1

SW

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Use the CURSOR buttons to adjust all the speakers to the same

volume.

 

 

 

Flashing

The volume can be adjusted between –12 dB and +12 dB in units of 1

Example: When the volume is set to –12 dB

dB.

 

 

 

 

while the test tone is being

 

 

 

 

 

produced from the subwoofer

b. When the “Manual” mode is selected

 

 

Flashing

 

 

 

Use the

and

cursor buttons to select the speaker from which you

 

want to produce the test tone, then use the

and

cursor buttons

 

to adjust so that the volume from the different speakers sounds the

 

same.

 

 

 

 

 

Example: When the volume is set to –12 dB while the subwoofer is selected

8

 

After the above settings are completed, press the ENTER button.

ENTER

The “Channel Level” screen reappears.

 

Press the ENTER button again, the “System Setup Menu” screen reappears.

*To cancel the settings, select “Level Clear” and “Yes” on the “Channel Level” screen, then make the settings again.

The level of each channel should be adjusted to 75 dB (C-weighted, slow meter mode) on a sound level meter at the listening position.

If a sound level meter is not available adjust the channels by ear so the sound levels are the same. Because adjusting the subwoofer level test tone by ear is difficult, use a well known music selection and adjust for natural balance.

NOTE: When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer’s own volume control.

*When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect ALL surround modes. Consider this mode a Master Channel Level adjustment mode.

*After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode, your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each surround mode on Page 36.

*You can adjust the channel levels for each of the following surround modes: DIRECT, STEREO, 5CH STEREO, DOLBY/DTS SURROUND, ROCK ARENA, JAZZ CLUB, VIDEO GAME, MONO MOVIE, and MATRIX.

Setting the digital in assignment

• This setting assigns the digital input jacks of the AVR-2801/981 for the different input sources.

1

At the System Setup Menu select “Digital In Assignment”.

 

20