Signal directionAudio cable
Connections
6
ENGLISH
ENGLISH

Cable indications

Connections

NOTE:
•Do not plug in the power supply cord until all connections have been completed.
•When making connections, also refer to the operating instructions of the other components.
•Be sure to connect the left and right channels properly (left with left, right with right).
•Making connections with the power turned on could result in noise or damage the speakers.
•Bunching the power supply cords and connection cables together could result in humming or noise.
Connect using the connection cables shown below.
Analog connections (Stereo)
A
R
L
R
L
Pin-plug cable
Digital connections (Optical)
B
Optical fiber cable
Audio signal
OUT IN
(White)
(Red)
A
R
L
AUDIO IN
R
L
R
L

Analog connections

Stereo amplifier
B
OPTICAL
IN

Digital connections

CD recorder, etc.
There is a protective cap over the optical digital output terminal. Remove the protective cap and insert the
plug firmly until it locks.

¢When connecting the optical digital output connector with an optical

transmission cable (commercially available)

Protective cap Match the
shapes
Remove the protective cap, match the shapes then
insert firmly all the way in.
•Store the protective cap in a safe place so as not
to lose it, and use it when not using the terminal.

Connecting the power supply cord

AC 230 V, 50 Hz
AC outlet
NOTE:
•Insert the plugs securely. Incomplete connections will result in the generation of noise.
•Do not unplug the power supply cord while the set is operating.