Operation

13

ENGLISH

ENGLISH

Using the timer play function

Also refer to the operating instructions of the timer device.

DCD-700AE (This unit)
Amplifier
Timer device
AC outlet

Turn on the power of the connected components.

Switch the amplifier’s input function to the function

to which the player is connected.

1
2

Load a disc in the player.

3

Set the audio timer for the desired times.

4

Turn the timer “ON”.

•The power of the components connected to the timer turns

off.

When the set time is reached, the power of the different

components automatically turns on and playback starts from the

first track.

5

If a problem should arise, first check the following:

1. Are the connections correct ?

2. Have you operated the player according to the Operating Instructions ?

If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.

Disconnect the power immediately and contact your store of purchase.

PageMeasuresCauseSymptom

Disc tray does not open. • The power is not on. • Turn on the power. 7
“NO DISC” is displayed even though
a disc is loaded.
•The disc is not properly loaded. • Reload the disc. 2, 3
“00 Tr 00 : 00” is displayed even
though a disc is loaded.
•The loaded disc is not a CD. • Load a CD. 2
Disc is not played when play button
is pressed.
•The disc is dirty or scratched. • Wipe the dirt off the disc or replace the disc. 3
No sound is produced or sound is
distorted.
•The output cables are not properly connected to the
amplifier.
•The amplifier’s function setting or adjustments are
not right.
•Check the connections.
•Check the amplifier’s function and controls and
adjust as necessary.
6
–
No digital signals are output. • The pure direct mode is set to “MODE 2”.
•The connection cables are not properly connected.
•The pitch control play mode is set.
•Change the pure direct mode setting.
•Check the connections.
•Set back to the normal playing speed.
4
6
9
Specific section of the disc cannot be
played properly.
•The disc is dirty or scratched. • Wipe the dirt off the disc or replace the disc. 3
Programmed playback is not possible. • The tracks have not been programmed properly.
•Programmed playback is not possible with MP3 and
WMA files.
•Program properly.
•Use a CD.
8
8
A CD-R or CD-RW disc cannot be
played.
•The disc has not been finalized.
•The recording conditions are bad or the quality of the
disc itself it poor.
•Finalize the disc then play it.
•Use a properly recorded disc.
2
2
Set does not operate properly when
remote control unit is operated.
•The batteries are spent.
•The remote control unit is too far from the set.
•Replace the batteries with new ones.
•Move the remote control unit closer to the set.
3
3
“Not Support” is displayed when
playing riles recorded in MP3 or
WMA format.
•You have selected a copyright-protected WMA file
or a file that cannot be played normally.
•Use the 8or 9button to select a different file. 11, 12

Troubleshooting

Others