Denon DN-2100F Clearing the A-Bseamless loop, Clearing all data, Hot Starts, English, A1 B, A2 B

Clearing the A-B seamless loop

While holding down the FLIP button, press the A button you want to clear (A-1 or A-2) for at least 2 seconds.

	FLIP	A		Off	Off
6	1	2	1	or	2
			A1 B	or	A2 B
			Off		Off

• The A-1 point (or A-2 point) and the B point are cleared.

NOTE:

•When the disc tray is opened, the start (A) and end (B) point settings are cleared.

Clearing all data

Press the FLIP button for at least 2 seconds.

ENGLISH

Fine-adjusting the start points (A-1 and A-2) and end point (B)

★The A-1, A-2 and B points can also be adjusted in the standby mode at their respective points.

Adjust the start point (A).

To fine-adjust the position of the A-1 (or A-2) point once it has been set, in the standby mode press and hold down the CUE button then push the “A” button that you wish to edit.

1	Flashing
	A	Flashing
CUE 1
	2	A1
CUE

•The stanby mode is now set to edit/fix either A-1 or A-2 points.

Use the Jog/Shuttle wheel to manualy search through the track in order to find your desired new start point. When found, press the same “A” button to resave.

	FLIP
7	LOOP

Off

2	SEARCH	SCAN
	I II

LOADING

•All data is cleared when the the flip button is held down for 2 seconds.

NOTE:

•When A-1 or A-2 is cleared during seamless looping, it may take about 2 seconds before A-1 or A-2 can be set again.

Adjust the end point (B).

Follow the same steps from 1 & 2 above, except, press and

3hold the CUE button and then the B button in order to edit your end B point, Then press the B button again to save your changes.

NOTE:

•It is not possible to set an A point at a position after the B point or the B point at a position before the A point.

“ LOADING ” indicator will flashed.

Hot Starts

★Hot starting is possible during a seamless loop or even without a B point being set.

With the data for A-1 or A-2 loaded, press the A-1 (or A-2) button to hot start.

•Playback starts immediately from the start point (A) when the button is pressed.

1• The A-1 or A-2 points can be set in advance so that in front of a live audience, you are able to jump from A to A on the fly. (slam-mix)

✽“H/S” is displayed once a hot start has been loaded.

✽While data is loading, hot start is only possible for that

point (A-*)

15